
Jason Jahnke

Well I will be receiving a SAFC II soon. Now I need to decide what wideband to get. Right now, I just want one to work with the SAFC,and that isn't so expensive. I can get a better set up with a guage and datalogging later on. Can I just get a bosch sensor and hook it up to the SAFC? That would save me a lot of money right now. And yes, I am completely new to tuning.
so, which one? and why?bosch wideband
zeitronix zt-2
innovate lc-1
aem uego
14point7.com JAW assembled
Thanks for your help
Last edited by specVnismo2004 (2008-10-09 20:47:15)

Offline

Don



specVnismo2004 wrote:
Well I will be receiving a SAFC II soon. Now I need to decide what wideband to get. Right now, I just want one to work with the SAFC, I can get a better set up with a guage and datalogging later on. Can I just get a bosch sensor and hook it up to the SAFC? That would save me a lot of money right now. And yes, I am completely new to tuning.
Thanks for your help
They are 2 separate things. The wideband needs to output to a gauge or a datalogger to work. I suggest the Zeitronix ZT-2
Offline

Jason Jahnke

my plans are to eventually supercharge.
in that case, i think i may be leaning to the basic LC-1 kit...
thanks guys

Offline

RJ



dont go lc-1 i hated it! and i am not the only one! sucks bc u have to recalibrate the sensor often and no gauge.. be smart and get the AEM UEGO you will not regret it i just got rid of the lc1 and aem is stupid easy to install over the lc1 too.. if your still stuck on lc1 i have auction on ebay that gets over in 2 days for my old lc1 http://cgi.ebay.com/ebaymotors/ws/eBayI … 2&rd=1 but i would strongly suggest the aem.. no shit only wires u hood up are a ground and switched 12Volt.. and done. just trying to give you a heads up.
Offline

Jason Jahnke

ok, well where can i get a uego for less than $300? cause that was the price on the aem site...
just found this:
http://www.streetsideauto.com/products. … upType=NON
AEM - Advanced Engine Management: UEGO: 30-4113
Description: UEGO Air/Fuel Ratio Gauge; Single Channel; Black Bezel; Black Face; Display Only; Incl. Sensor;
Price: $198.89
will that work?
Last edited by specVnismo2004 (2008-10-09 18:30:07)

Offline

Jason Jahnke

bump for help

Offline

RJ



http://cgi.ebay.com/ebaymotors/AEM-GAUG … enameZWDVW
thats aem wideband for 240 sihpped and has a gauge with it. enjoy!
Offline

Josh




I have the lc1 with a xd-16 gauge with ssi4 datalogger setup and LOVE it..Works top notch for me.
Lifes to short to drive a shitty car, get in a Spec V-T
\Offline

Jason Jahnke

found this: i may do this, for now...http://www.amazon.com/Innovate-DB-Wideband-Kits-Blue/dp/B001HB4YH6/ref=sr_1_29?ie=UTF8&s=automotive&qid=1223603405&sr=1-29
nope. scratch that.
Last edited by specVnismo2004 (2008-10-18 22:01:46)

Offline

Josh




ive never seen one that cheap..do it.
Lifes to short to drive a shitty car, get in a Spec V-T
\Offline

Jason Jahnke

so yea. turns out that it was, in fact, too good to be true. it was really just the afr gauge, at the same price innovate sells. the guy i've been in contact with is looking into getting a zt2 for me. they are gonna give me a little bit of a discount. not much, but something is better than nothing.
so now my SAFC II is sitting in my room waiting on a wideband... oh well...

Offline

Derek



aem uego + safc2 ftmfw!
Offline

Jason Jahnke

hows about this? 
http://cgi.ebay.com/ebaymotors/Zeitroni … 06.c0.m245
nobody better steal this on me...

Offline




i think your stil confused as to what a safc-II does.
the safc-II is independet of the wideband. hooking it up does nto require a wideband. You cannot hook the safc-II to a wideband. but they are rather used in conjunction. but you can use each one seperately.
ITs only when your tunning that you need a wideband.
So you can still install the safc-II at the momment an dleave it at 0 corrections

Offline

Jason Jahnke

no i'm not. i understand that i don't wire up the wideband to the afc. that was finally made all too clear to me the other night...
but the zt2 is what i want eventually, and if i can get a hold of this one, awsome... if not, i may just settle for a plain sensor and gauge for now...
i posted this to get feedback on the item, if it looks fishy, etc... not if i can hook it up to a afc...
Last edited by specVnismo2004 (2008-10-29 10:06:41)

Offline