This thread has been viewed by: 97 unique users.
2008-09-17 07:37:58 (16 weeks 15 hours 19 minutes 9 seconds) #1866911 | | view posts since this #1
- boogerboy72
- 6th Gear Junkie
- Registered: 2007-08-29
- Reads: 9074
- Posts: 1591
- Last seen: 11.39 days ago
- Thanks given: 0
- Thanks received: 5
- Vehicle: '04 SE-R Spec V Member #1823
clay
Modifications : 32
Taming the Squid: 2004-2006 Megasquirt1 v3.0 wiring guide
this thread is winnar.
ty for the wiring!
Offline
2008-09-17 14:13:51 (16 weeks 8 hours 43 minutes 16 seconds) #1867216 | | view posts since this #2
- darsondriss
- Ve-tAc Hater
- From: FWB FL
- Registered: 2007-03-02
- Reads: 13500
- Posts: 2572
- Thanks given: 1
- Thanks received: 7
- Vehicle: '02 SE-R Spec V
- 1/4mile: 14.126 @ 103.96 Member #630
- Showoff page
Michael
Modifications : 45
Re: Taming the Squid: 2004-2006 Megasquirt1 v3.0 wiring guide
mines not as fancy as pimps but it works...
MS wire ECU pin number ECU wire color
ECU Power 109 R/G
ECU Ground 106 B
IAT 84 Y/G
CLT 93 Y
TPS 73 W
Injector 1 101 R/B
Injector 2 102 R/W
Injector 3 103 R/Y
Injector 4 104 R/L
Ignition 1 21 BR
Ignition 2 22 PU
Ignition 3 23 L/R
Ignition 4 24 GY/R
Fan Control 27 LG/B
Boost Control Solenoid ground Launch relay switch out
Wideband power Innovate analog out White
Wideband ground Innovate analog ground ground
Boost control relay
coil in ecu power
coil out ground
switch in 12v source
switch out solenoid power
Launch Control relay normally closed
coil in connector 12v
coil out ground
switch in ground
switch out MS launch wire
101 102 01 02 03 04 05 06 07 08 09 10 58 59 60 61 62 63 64 65 66 67 109 110
103 104 11 12 13 14 15 16 17 18 19 39 40 41 42 43 44 45 46 47 48 68 69 70 71 72 73 74 75 76 111 112
49 50 51 52 53 54 55 56 57
105 106 20 21 22 23 24 25 26 27 28 29 77 78 79 80 81 82 83 84 85 86 113 114
107 108 30 31 32 33 34 35 36 37 38 87 88 89 90 91 92 93 94 95 115 116
Online
2008-09-29 15:13:30 (14 weeks 2 days 7 hours 43 minutes 37 seconds) #1877528 | | view posts since this #3
- gurov
- Administrator
- v--- russian chicken
- From: Freehold, NJ
- Registered: 2006-03-08
- Reads: 18069
- Posts: 6933
- Thanks given: 29
- Thanks received: 33
- Vehicle: '04 SE-R Spec V
- 1/4mile: 13.200 @ 107.00 Member #1
- Awards : 4
- Showoff page
- Feedback page
- Website
gennady gurov
Modifications : 58
Re: Taming the Squid: 2004-2006 Megasquirt1 v3.0 wiring guide
the diode board goes to the green wire in yours, which is a ground.
it needs to go to the white wire.
04 turbo @ 14 psi -
MegaSquirt-I standalone - unit #0 (fuel only mode), gsquirt board v1.0, Pivot 3 Drive Throttle Controller,
J&S UltraSafeguard individual cylinder knock suppression system, Autosport Wiring Engine Harness
660cc msd injectors, 255 walbro fuel pump, JGY fuel rail, t3/t4 57trim, Coolingmist Varicool Progressive Alky controller,
Shurtank with 150psi alky pump.
05 automatic se-r: upcoming turbo project
04 BMW 325xi - daily driver
Online
2008-11-15 14:18:36 (7 weeks 4 days 7 hours 38 minutes 31 seconds) #1924272 | | view posts since this #4
- blackdoutspec
- Sleepin At The Tree
- From: Euclid
- Registered: 2007-06-09
- Reads: 3464
- Posts: 225
- Thanks given: 0
- Thanks received: 0
- Vehicle: '03 SE-R Spec V Member #1132
- Showoff page
Shawn
Modifications : 52
Re: Taming the Squid: 2004-2006 Megasquirt1 v3.0 wiring guide
So is there a diagram for an 03 yet?
Offline
2008-11-15 18:46:09 (7 weeks 4 days 3 hours 10 minutes 58 seconds) #1924468 | | view posts since this #5
- darsondriss
- Ve-tAc Hater
- From: FWB FL
- Registered: 2007-03-02
- Reads: 13500
- Posts: 2572
- Thanks given: 1
- Thanks received: 7
- Vehicle: '02 SE-R Spec V
- 1/4mile: 14.126 @ 103.96 Member #630
- Showoff page
Michael
Modifications : 45
Re: Taming the Squid: 2004-2006 Megasquirt1 v3.0 wiring guide
same as 02
Online
Pages: 1
- Index
- » ECU Tuning & Engine Management
- » Standalone Fuel / Engine Management Systems
- » Taming the Squid: 2004-2006 Megasquirt1 v3.0 wiring guide
This thread has been viewed by: 97 unique users.