Views: 112
This thread has been viewed by: 3 unique users.
This thread has been viewed by: 3 unique users.
2008-07-23 21:58:57 (23 weeks 6 days 20 hours 25 minutes 14 seconds) #1816728 | | view posts since this #1
- gurov
- Administrator
- v--- russian chicken
- From: Freehold, NJ
- Registered: 2006-03-08
- Reads: 18056
- Posts: 6932
- Thanks given: 29
- Thanks received: 33
- Vehicle: '04 SE-R Spec V
- 1/4mile: 13.200 @ 107.00 Member #1
- Awards : 4
- Showoff page
- Feedback page
- Website
gennady gurov
Modifications : 58
12 pin molex connector
stopped by radio shack today and found these. 12 pin molex connectors, these would be awesome to use when doing any kind of wiring that could potentially ever require being disconnected, a way to make custom clean installations:
04 turbo @ 14 psi -
MegaSquirt-I standalone - unit #0 (fuel only mode), gsquirt board v1.0, Pivot 3 Drive Throttle Controller,
J&S UltraSafeguard individual cylinder knock suppression system, Autosport Wiring Engine Harness
660cc msd injectors, 255 walbro fuel pump, JGY fuel rail, t3/t4 57trim, Coolingmist Varicool Progressive Alky controller,
Shurtank with 150psi alky pump.
05 automatic se-r: upcoming turbo project
04 BMW 325xi - daily driver
Online
2008-07-23 22:01:08 (23 weeks 6 days 20 hours 23 minutes 3 seconds) #1816731 | | view posts since this #2
- MajorMods
- Ve-tAc Hater
- From: Coral Springs, FL
- Registered: 2006-07-05
- Reads: 9695
- Posts: 8984
- Thanks given: 2
- Thanks received: 5
- Vehicle: '07 SE-R Spec V Member #131
- Showoff page
- Feedback page
- Website
Jeff
Modifications : 36
Re: 12 pin molex connector
i used these in the past for all my gauges so in case they ever came undone, its just a plug away. i used the 6 or 8wire not the 12 but none the less, itd be cool for safc2 installs, gauges, etc.
Offline